Home Assistant and Veraplus incompatibility

[geoay]

I just installed Home Assistant on my QNAP NAS in order to federate all my house systems on the same UI.
I tried to associate my Veraplus to HA but it didn’t work
I read that HA and Veraplus are incompatible (what a deception, most of my devices are Veraplus Zwave connected)
Could you confirm this bad news ?
Is there any bypass ?

[JonathanB]

Hello @geoay

Unfortunately, we do not have a Home Assistant to check, but you can try following these posts:

Made My Vera Stable using Home Assistant (This is AWESOME!)

I read this thread a few months ago and have recently acted on it. My Vera started behaving erratically, in particular refusing to send http commands as luup. I used these to put my Synology surveillance station into Away mode (I.e. to turn on motion detection for my IP cameras). SS and Vera worked well together - I could exchange POST commands back and forth to create a good integrated home security setup. But then the luup just stopped working. After many hours of checking, rebooting, and re…

Adding Z-Wave power monitors to the new Home Assistant Energy Dashboard

OK, thanks for the clarification.

Siri via HomeKit via Home Assistant to Vera

I have been experimenting with Home Assistant and it’s various integrations. First I integrated with my Vera system then I stumbled upon the HomeKit integration. It was dead simple to set up and now I can (reliably) use Siri on my Apple Watch or iPhone to control most of my Vera devices. I did try the Siri Shortcuts feature in Vera Mobile, but it often timed out opening the app/running the command. Screen shots of the Home app on iPad are below. [image] [image]