Vera setting thermostat as COOL instead of HEAT and other random things

Other Devices & Integrations Climate Control & Temperature Sensors
1

Hi,
I’m using some Remotec zxt-120 thermostat, and I have some random behavior with my Vera.

  1. I have a daily scene starting the heater in the morning at a given time. The scene is suppose to put the HVAC in HEAT mode at a given temperature.
    => However, in about 20% of the times, the HVAC is set to COOL (and Vera reports in the dashboard that it is cooling).

  2. Also, everyday at 10:22am the thermostat is reset on all . However I have no scene at that time, and I can’t figure out why this happens.

  3. At time, the thermostat settings are changed randomly. It is somewhat annoying since the HVAC made many beeps when Vera sends some changes.

2

Something similar happened to me, but in my case it is not a thermostat nor a heater but just an Air Conditioner with cooling and no heating capabilities. Still, it would sometimes show “HEAT” mode on the interface.

What seems to be working is making sure the mode(NewModeTarget: CoolOn) is sent after(I do it 5 seconds later) the specific temperature command. Just sending the temperature command turns my A/C on.

I’m using PLEG by the way and UI7.