I’m brand new to Z-Wave but I’ve managed to get the Vera3 running and a few devices registered and even a few scenes working but I’ll be darned if I can figure out how to get these CA3000 switches paired? The instructions included show how to wire them up and they are working manually but I can’t figure out how to get them paired. I don’t see a button to put them in pairing mode and the many forum and internet searches haven’t turned up anything either. Any pointers would be greatly appreciated.
Is the LED blinking? If it isn’t, it has already been included in another network?
Put Vera in Exclude mode, and hit on or off. Wait for Vera to exclude an unknown node. Then put Vera in Include mode, and hit on or off and wait for Vera to include it.
That was the ticket, thanks!