Suddenly: DSC Alarm Panel: Remote arm is not enabled

Plugins & Plugin Development DSC Alarm System
#1

I’m suddenly getting this error message with my DSC and EVL-4 with Vera-Edge. It’s been working fine for about 12-mos, but suddenly stopped working this week. As a result, none of my scenes work which are associated with my dsc alarm panel. I backed up and reset to factory settings, then uploaded the b/u. My F/W is: 1.7.2139

The eyez-on web browser shows all is working fine. I can arm/disarm and see all of my zone status’ like normal.

In Variables, Enable remote arm has always been set to: disarm

Any help would be greatly appreciated! Shannon

#2

Update: I called VERA. They suggested I go install a b/u from 1-week ago [when it was working fine]. I did, and it works fine, now… I guess it has nothing to do with the F/W, but something happened on 10/31 to cause the DSC Plugin to stop working…

I’m all good, now. Shannon