SetLoadLevelTarget (un)expected behavior?

I’ve tried searching this subforum and others but haven’t found the answer to a simple noob question:

The SetLoadLevelTarget device actions in a PLEG I’m working on also turn on the lights. Is this the expected behavior? I would like to reset the dim levels of several lights each morning without turning the lights on and having to immediately turn them back off. Is there a way to do this?


Is this the expected behavior?
Apparently its not what you expected, but it is the Vera defined behavior.

Thanks for the confirmation. Are you aware of any way to achieve what I’m trying to do in PLEG?


In my experience the Fibaro and Qubino dimmer modules do not respond to the SetLoadLevelTarget and remain off. They Fibaro will turn on to that load level and the Qubino even goes to full strength for a short moment. Still have not figured out how to get a round that. So to me it is not Vera behaviour but Z-Wave dimmer module behaviour.

Cheers Rene

Rene, thank you for the comments.