Re-setting vera after a test run

I would like to do a trial run of vera at my home before I use it on my vacation home. I’m sure it will still recognize the remote devices that I bring with it however I didnt know if plugging vera into a new internet provider in a new location would require a new set up ? or perhaps resetting something ? or a new IP address ? or? ??? Can anyone give some advice here?

Thanks !

It’s won’t care about the ISP, only the network topology. Assuming you will be plugged it into an existing LAN in both locations you will be fine there. You will probably want to run the z-wave network heal after you get it setup in the new location, so the devices can figure out which other devices are near them.

Very helpful. Thanks