I just installed this plug-in and followed the instructions provided. When manually entering the IP address, you receive a No Implementation error when clicking the Set button; however, I was able to get detection to work. I am running UI7.
I also cannot get the Read Panel option to work. First I received a No Connection error after setting getting the IP set through detection. I restarted the luup engine and after about 10 seconds of see the attempting to read panel message a single beep is heard on my control panels and about 20 seconds later the message Installer Code Invalid displays. I know the installer code is correct as I can enter it on my main control panel via [Installer Code]+800 and it enters programming mode.
Is there something I have missed? Thank you, I’m looking forward to getting this all setup.