I have found that the new update has solved my triggering problems with both of my HSM-100’s. Both are working fine now. The trick is to press the blue button and within 60 seconds press “configure now”. Sometimes it takes more than one attempt. I also found that by setting option 2 (time out) in the advanced section to 1 minute made testing very easy, well worth the setting change.
I did notice that I don’t have the battery level readings any more, did anyone else notice this? One more thing to watch for, be careful when using rechargeable batteries with these motion sensors the voltage is a little lower and I found that the reliability of the sensor was not to be trusted.
Has anyone tried to trigger on the temp and light levels?