I am trying to get my GE IS-ZW-STAT-100 working. I successfully added the node (2 nodes actually, one for the themostat and one for the sensor?) There does not appear to be a thermostat template ready yet, so I assume I need to go into Device Configuration > Details in order to communicate with it. From that page, I am able to adjust the thermostat mode (off and heat) successfully. I am unable, however, to set the temperature. I tried entering both 1 and 0 for the setpoint mode but the thermostat does not seem to change the set temperature.
I’m brand new to this, so any help in troubleshooting is greatly appreciated.