Vera reboots when trying to go into Learn mode

Community Playground General Discussions
1

I’m having difficulty entering Learn mode and was wondering if anyone can figure out why by taking a look at the log file. I would push it once, but nothing happens. As soon as I push it a second time, the z-wave light goes off and the Vera reboots itself.

Below is the log. Any ideas?

03	11/26/11 23:31:19.391	JobHandler_LuaUPnP::Reload: reload Critical 1 m_bCriticalOnly 0 dirty data 1 <0x640e>
06	11/26/11 23:31:19.627	Device_Variable::m_szValue_set device: 1 service: urn:micasaverde-com:serviceId:ZWaveNetwork1 variable: NetStatusID was: 1 now: 2 #hooks: 0 upnp: 0 v:0x7f3200/NONE duplicate:0 <0x640e>
06	11/26/11 23:31:19.628	Device_Variable::m_szValue_set device: 1 service: urn:micasaverde-com:serviceId:ZWaveNetwork1 variable: NetStatusText was: OK now: Resetting ZWave Network #hooks: 0 upnp: 0 v:0x80c2d0/NONE duplicate:0 <0x640e>


01	11/26/11 23:17:12.498	Mongoose XXX-mg_stop1 0x7731e0 1 1 <0x400>
01	11/26/11 23:17:14.510	Mongoose XXX-mg_stop2 0x7731e0 2 1 <0x400>
01	11/26/11 23:17:14.511	Mongoose XXX-mg_stop3 0x7731e0 2 1 <0x400>
01	11/26/11 23:17:14.512	Mongoose XXX-mg_stop4 0x7731e0 7825728 1 <0x400>

2011-11-26 23:17:14 - LuaUPnP Terminated with Exit Code: 245

2011-11-26 23:17:14 - LuaUPnP crash
2

I just upgraded to 1362, hoping that would solve my problems including a zone controller with local load ( see here: http://forum.micasaverde.com/index.php/topic,7934.msg50805.html#msg50805 )

When I get to “Adding local load # 1” I too get the “LuaUPnP crash”

The device I just added is sort of there, but not really. I can associate things to the buttons, but hitting them shows “Transmit ok” but nothing happens. The LED indicators seem to be correct, based on programming 1 button.

I supposed a support ticket.