I am working with PLEG on an old VeraLite with new UI7 install running the latest firmware 1.7.1030, PLC 8.21 and PLEG 8.11.
I have Conditions with a logic expression like this:
(AVClosetCurrentTemperature>TempWarm) and (AVClosetCurrentTemperature<TempHot)
In the status report, it just shows:
(AVClosetCurrentTemperature>TempWarm) and (AVClosetCurrentTemperature
Same when looking at the main Conditions page. Now if I go edit the condition, the whole logic is there. And the logic seems to work - I just know the status should show the whole logic expression.
Mostly the reason I am worried about this is that I am having trouble saving PLEG changes. At this point I reload LUA after every single PLEG change to make sure it stuck before I go any further. And am rebooting on a regular basis. I don’t have this problem with my VeraSecure with slightly older firmware (1.7.3832) and same PLEG version.