After upgrading to Luup-release 843, The 3-in-1 is not properly configured.
I cannot see that it’s three sensors, but I can see the device under devices.
Has anyone any hints or tips how to get it to work again?
After upgrading to Luup-release 843, The 3-in-1 is not properly configured.
I cannot see that it’s three sensors, but I can see the device under devices.
Has anyone any hints or tips how to get it to work again?
I see three sensors but the temperature is kinda odd and the brightness doesn’t seem to work?
Also, I’ve tried to add the additional Z-wave commands but the motion detector doesn’t seem to be taking them?
Any thoughts?
Ver: 1.0.843
Kastrup, please go to advanced, logs and enable verbose logging. Then press the blue button on the 3-in-1 sensor, which should cause it to start configuring. Then submit a trouble ticket by going to Advanced, tech support.
Best Home Automation shopping experience. Shop at Ezlo!
© 2024 Ezlo Innovation, All Rights Reserved. Terms of Use | Privacy Policy | Forum Rules