The nodes should show their neighbors. If they don’t maybe those Z-Wave devices don’t spport it? I’ll double-check in our test system that this is working.
guys, just to chime on on the topic(or one of them) here: I have nothing but intermatic modules, not one of them indicates that it has any neighbors
I wanted to ask about this for quite some time, but was forgetting…
I have mainly Leviton devices and none of them report their neighbors too.
I also have/use ThinkEssentials from ControlThink, and I show no neighbors there either. I wondered if this was because all of my nodes are within range of the primary controller, and so no routing is needed.
D.