Was working on adding some new wiring over the weekend and had to shut off the breakers for about half of my house. When I turned the lower back on, three of my controllable outlets no longer were controllable. The status light now flashes red. Are these outlets toast? Has anyone seen this behavior before?
It’s been reported before. Some old CA600s seem to lose their programming(reset to factory default) when they lose power. You need to delete the device(CA600) in Vera. Then you need to include the CA600 again.
Of course, the next time they lose power…
I was able to exclude and include the outlets. However now I have several phantom devices I can’t get rid of.