No Feedback from Wayne Dalton Thermostat

Other Devices & Integrations Climate Control & Temperature Sensors
1

I’ve just added a Wayne Dalton WDTC-20 Thermostat to my system. I can properly set the operating mode (Heat/Cool/Off) of the thermostat from the Vera UI and can also set the set points though I am having the exact same off by 27 degree bug that has been reported by others.

The problem that I’m having is that I don’t get any feedback of the set points or the mode in the Vera UI. I’ve already tried removing and re-adding the thermostat. I’ve tried setting the poll interval to 10 seconds and that didn’t help either.

Any help would be greatly appreciated.

Thanks

Jay

2

Never mind. After leaving the thermostat running over night, I came back to it this morning and new the feedback is working fine. Go figure.