Newest firmware bricked my Vera

Vera Controllers, Services & Devices Vera Controllers & Cameras
1

[ol][li]I posted a message about this last night and it seems to have vanished off the board. [/li]
[li]The latest release (UI7 ▾ Version 7.0.4 (1.7.513/1.7.961) ▾ Feb. 3, 2015
Last Updated: Feb 07, 2015 06:31PM UTC) has bricked by vera - flashing green/orange light[/li]
[li]Despite following the instructions to “recover” the vera, I can never “see” the vera with the tool to recover.[/li]
[li]I had a backup unit I was prepping for another purpose, so I set that up and applied my backup; now NONE of my z-wave devices work at all despite clicking to restore network. [/li]
[li]Wasted 5 hours on this last night and I’m very cranky now [/li][/ol]

Any advice would be appreciated

2

Did you try this:
http://forum.micasaverde.com/index.php/topic,30785.msg220534.html#msg220534

If so, you can try this:
http://forum.micasaverde.com/index.php/topic,30785.msg221041.html#msg221041

3

I wish I could. All I can get the Vera3 to do is blink a green/orange light. Nothing else, no access, rebooted/reset many times following the wiki, no access to telnet since it doesn’t even show up with the tool vera provides.

4

You need to call Vera tech support. They have tricks to recover “bricked” Veras. They’ve done it for me a couple of times.

5

Thanks. I think the zwave repaired itself finally on a backup unit minus 2 devices.

However, I will still need to recover the bricked one. Thanks for the replies.
(note to self, do NOT upgrade firmware right before you plan to go away)