GE/Jasco 3-Way Binary (On/Off) Switch Setup with Aux Switch and Triggering Scene

Other Devices & Integrations Lighting & Load Control
1

I have primarily GE Z-Wave Switches in my house.

In one area I have the Switch setup with an Aux unit to create a 3way switch scenario.

With Wink, If I create a robot that turns on other lights or turns them off with this switch, it will turn on and off all of the selected lights even if I use the Aux Switch.

I Tried to set this up on a Vera3 last night (Switches Paired to Vera, not Wink when I tried this). The Primary switch works flawlessly, but when I use the Aux switch it will not activate the Scenes.

Is there a way to fix this, has anyone else done this?

2

If Wink robots actually work when activating the Aux switch, then I’d recommend using Wink.

The Aux switch does not notify Vera of state changes, you must wait until Vera polls the device before the change is detected. The primary switch can/will notify Vera, if it is speaking directly to Vera and not being routed through intermediate nodes.

The subject has been discussed many times[url=https://www.google.com/search?q=site%3Amicasaverde.com+ge+switch+trigger]site:micasaverde.com ge switch trigger[/url] - Google Search