Alarm Connect to Fibaro Universal Sensor?

Other Devices & Integrations Door Locks & Sensors
1

I’m hoping someone can provide some guidance on how to connect the Fibaro Universal Sensor. It’s got so many wires/inputs/outputs, I’m getting a little lost.

Here is what I’m trying to accomplish - I want to be able to arm/disarm my alarm from Vera. Additionally, I want to be able to know the state of the Alarm from Vera (armed/disarmed).

I have the appropriate wires from my alarm system (e.g. a pair that needs to be closed to arm and opened to disarm), but not sure what to connect where in the Binary Sensor. Specifically, what do I attach to the Out 1/Out 2 of the Fibaro? What do I attach to the IN1, IN2 of the Fibaro?

A photo/diagram would be awesome, but any guidance from someone who has done this would be really helpful. The Fibaro docs all show a motion sensor, which isn’t part of my setup.

thanks in advance!

2

The fiber binary sensor is no output device.
The output’s are copies of the input so you can intercept a signal but not initiate one from the controller

3

[quote=“Jacob, post:2, topic:190461”]The fiber binary sensor is no output device.
The output’s are copies of the input so you can intercept a signal but not initiate one from the controller[/quote]

Reall? Hmmm. When then can I use to open/close a circuit while supplying no charge? The relays all supply a charge. I was sure I read that people were using the binary sensor to arm/disarm their alarm…