ACT ZTM230 (European) buttons recognition

Community Playground General Discussions
1

I am trying to use ACT ZTM230 controller with Vera, but it does not trig to any other than referring “Button 0” as event source. Otherwise Vera seems to be happy & showing green cog. A am pretty new in playing with Vera or Z-Wave, but this smells like compatibility problem similar to some other ACT devices reported here.

This is what Vera tells:
Capabilities 201,12,0,4,18,0|32,37,38,39,80,112,114,115,133,134,135,239,
Version 6,1,99,1,10
Manufacturer ACT - Advanced Control Technologies
Model 1,21581,13104

/Timo

2

Welcome to the club!

I’m struggling with Popp/duewi switches and window coverings, Merten 4 Push Button (controller) and a TrickleStar controller.

See also Mantis #568 and #571.

It’ s all about standards… :cry:

…huwu

3

Hi,

I’ve just installed my first Z-Wave environment with Vera.

The Duewi Shutter switch runs fine with Vera but the slide bar will not work correctly.

  1. If I shut down the Jalousie by hand (eg. 50%) Vera will show this correctly after polling
  2. If I try to do this by Very GUI the switch will click, but nothing will happen
  3. so I’ve used a voltmeter to see what will happen and what I’ve seen is, that he will bring 220V on one of the actor ports but nothing will hapen ?!?

Until now I have no clue whats going wrong with it. Normaly the motor should work in any direction with power but he don’t do anything …

Maybe some one else will have some more experience with this Roller Actors?

My Hardware:
MicasaVerde Vera
5x duewi 054368 Roller Shutter Switch (same as POPP Interact Actor Jalousie)
1x ACT Homepro ZRP200